Retro GEM Wii Installation
Retro GEM Logo
Introduction
Disclaimer
This kit is for advanced installers only. Install at your own risk. We cannot be held responsible for damage to your console and/or kit.
Important Information
The kit is compatible with all Wii Models. There are three different installation types depending on your Wii Motherboard. These will be referred to as 6 Layer, 4 Layer, Wii Mini.
6 Layer Models:
- RVL-CPU-01
- RVL-CPU-10
- RVL-CPU-20
- RVL-CPU-30
4 Layer Models:
- RVL-CPU-40
- RVL-CPU-50
- RVL-CPU-60
Wii Mii:
- RVK-CPU-01
- RVK-CPU-02
Here is a video installation of a 4 layer board. Please use it for references and techniques.
Kit Contents
- Wii Main Flex
- USB Sniffer Board
- USB Sniffer Flex
- Mini HDMI Adapter Board
- Male HDMI Adapter
- 150mm 18p FFC Cable
- FR4 Mount
- M1.6 Screw mount (2x)
- M1.6 Screw 3mm (2x)
- Wifi Antenna
- .5mm Thermal Pad
Items Required
- Temperature Controlled Soldering Iron
- Leaded or Lead Free Solder
- Non-Corrosive, No Clean Flux (Amtech 559 / Kester 959T)
- 99% Isopropyl Alcohol
- Multi Meter
- Exacto Knife
- Small screw Phillips screw drivers
- Side cutters
Step 1 - GEM Jumpers
Set the Retro GEM Jumpers and attach the WIFI antenna along with the mini HDMI connector. Make sure the mini hdmi is plugged in all the way sometimes it can be stubborn to insert fully.
<a href="https://docs.pixelfx.co/GEM_ASSETS/WII_JUMPER_SMALL.JPEG"><img src="https://docs.pixelfx.co/si.php/500//GEM_ASSETS/WII_JUMPER_SMALL.JPEG"></a>
Retro GEM jumper information Tool
https://docs.pixelfx.co/fxdigital-config.html