Retro GEM GC Installation
Place Holder
Introduction
Disclaimer
Disclaimer: This kit is for advanced installers only. Install at your own risk. We cannot be held responsible for damage to your console and/or kit.
Important Information
The kit is compatible with both DOL-001 and DOL-101
While the kit will work with the Panasonic Q its not outlined in the this guide. Make sure to grab Jesusburnsneon's [adapter] if you are doing a Q.
The doc assumes you are doing a no cut (Replace analog or digital port) installation in your GameCube.
If you are upgrading an existing GCDual or other installation and wanting to do the case cut you will need the 3D printed spacer to mount.
[[1]]
Blueshell3D has created a very nice [printed backplate] that allows for full-size HDMI in the GCDual cut location. This is a great option for people wanting to keep both ports while keeping full size HDMI at the same time.
Kit Contents
- GC Main Flex
- Full Size HDMI Adapter Board
- Male HDMI Adapter
- 150mm 18p FFC Cable
- FR4 Mount
- M1.6 Screw mount (2x)
- M1.6 Screw 3mm (2x)
- Wifi Antenna
- M2 Screw
- M2 Nut
- Plastic HDMI mount
Items Required
- Temperature Controlled Soldering Iron
- Leaded Solder
- Non-Corrosive, No Clean Flux (Amtech 559 / Kester 959T)
- 99% Isopropyl Alcohol
- Multi Meter
- Exacto Knife
- Small screw phillips screw drivers
- Side cutters