Retro GEM GC Installation: Difference between revisions
No edit summary |
No edit summary |
||
| Line 50: | Line 50: | ||
Set the Retro GEM Jumpers and attach the wifi antenna. | Set the Retro GEM Jumpers and attach the wifi antenna. | ||
Retro GEM jumper information: | |||
[[https://docs.pixelfx.co/fxdigital-config.html]] | [[https://docs.pixelfx.co/fxdigital-config.html:[https://docs.pixelfx.co/fxdigital-config.html]] | ||
== Disassembly == | == Disassembly == | ||
This guide will not go over the disassembly of the GC. Guides are available online. | |||
Once the motherboard is free (Leave the heatsink attached unless you plan to replace the thermal pads), set it to the side. We now need to decide which port you would like the HDMI to replace. This install will remove the the digital port in the DOL-001. Removing the analog port is also the same procedure. | |||
Insert the full size connector into the plastic mount. It will snap into place. Then secure the HDMI board with the M2 nut and screw. The M2 screw will need to be trimmed flush. Do not overtighten | |||
<a href="/GEM_ASSETS/GCFULL_SMALL.JPEG"><img src="/si.php/500/GEM_ASSETS/GCFULL.JPEG"></a> | |||
Align the top and bottom shields and check the alignment with the HDMI connector. It needs to fit in to the hole, so mark and remove any of the metal shield. | |||
I use side cutters and pliers to cut and fatigue bend the metal off. | |||
<a href="/GEM_ASSETS/GCSHIELD_SMALL.JPEG"><img src="/si.php/500/GEM_ASSETS/GCSHIELD.JPEG"></a> | |||
== Installation == | == Installation == | ||