Retro GEM Wii Installation: Difference between revisions
| Line 165: | Line 165: | ||
[[File:WII_4LAY.png|500px]] | [[File:WII_4LAY.png|500px]] | ||
Install the Mini HDMI connector. Desolder some of the area around the points to get a better fitment. Make sure the PORT is flat and squared out with the console when attaching. | |||
[[File:WII_6_HDMIMOUNT.JPEG|500px]] | |||
Breakdown the small flex cables to two small cables. Just grab them with your fingers and pull apart. | |||
Attach the cables as shown to the USB Sniffer board. Pay attention to the orientation of the cables, the traces should be on the solder side. | |||
[[File:WII_SNIFF1.JPEG|500px]] | |||
Solder to the main flex next. Again pay attention to the orientation. | |||
[[File:WII_SNIFF2.JPEG|500px]] | |||
Before soldering the other side of the sniffer. Prep the sniffer by partially removing the 3M tape backer . Get your alignment and solder the flex. Take careful note of the orientation. As the hookups for the 4 layer and Wii mini will be on the top side. | |||
Take note that flex on the 6 layer is flipped vs the 4 layer when connecting to the motherboard. | |||
[[File:WII_4_USB.JPEG|500px]] | |||
== Step 3 - Wii Mini Installation == | == Step 3 - Wii Mini Installation == | ||
== Step 4 - Finishing Up == | == Step 4 - Finishing Up == | ||