Retro GEM PS2 Fat Installation: Difference between revisions
| Line 396: | Line 396: | ||
The power supply pins need to be cut shorter so it does not make contact with the GEM board. After install the power supply. Trim the pins. | The power supply pins need to be cut shorter so it does not make contact with the GEM board. After install the power supply. Trim the pins. | ||
Install the GEM board as shown. Bend the arm on the right so the gem can slide in. Push the arm back in place and secure the GEM using the OEM power supply screws. | Install the GEM board as shown. Bend the arm on the right so the gem can slide in. Push the arm back in place and secure the GEM using the OEM power supply screws. | ||
| Line 405: | Line 404: | ||
[[File:GEM_PS2_METALBEND_SMALL.JPG|500px]] | [[File:GEM_PS2_METALBEND_SMALL.JPG|500px]] | ||
=== Rev B === | |||
Route the cable as show and install the bottom shield. | |||
==== Mini HDMI Mount ==== | |||
===== No Cut ===== | |||
===== Cut ===== | |||
==== GEM Mount ==== | |||
== []()Step 8 - Finishing up the SPDIF wire == | == []()Step 8 - Finishing up the SPDIF wire == | ||