Retro GEM DC Installation: Difference between revisions

← Older edit Newer edit →

@@ Line 1: / Line 1: @@
+== Introduction ==
-**Disclaimer:** This kit is for **advanced installers only**. Install at your own risk. We cannot be held responsible for damage to your console and/or kit. Each kit is individually tested and confirmed working before being shipped.
+=== Disclaimer ===
+ This kit is for advanced installers only. Install at your own risk. We cannot be held responsible for damage to your console and/or kit. Each kit is individually tested and confirmed working before being shipped.
+=== Important Information Before You Begin===
-## []()Before you begin:
 The kit is compatible with all VA0 and VA1. VA2 is not supported
@@ Line 11: / Line 14: @@
 [DCD_DRILLBLOCK.stl](https://docs.pixelfx.co/GEM_PRINTS/DCD_DRILLBLOCK.stl)
-**Kit includes:**
+=== Kit Contents ===
--   DC Main Flex
+*DC Main Flex
--   HDMI Adapter Board
+*HDMI Adapter Board
--   Male HDMI Adapter
+*Male HDMI Adapter
--   150mm 18p FFC Cable
+*150mm 18p FFC Cable
--   Plastic Panel block
+*Plastic Panel block
--   M2 Nuts (1x)
+*M2 Nuts (1x)
--   M2 4mm Screw (1x)
+*M2 4mm Screw (1x)
--   M1.6 3mm Screw (2x)
+*M1.6 3mm Screw (2x)
-**Items required**
+=== Items Required ===
--   Temperature Controlled Soldering Iron
+*Temperature Controlled Soldering Iron
--   Leaded Solder
+*Leaded Solder
--   Non-Corrosive, No Clean Flux (Amtech 559 / Kester 959T)
+*Non-Corrosive, No Clean Flux (Amtech 559 / Kester 959T)
--   99% Isopropyl Alcohol
+*99% Isopropyl Alcohol
--   Multi Meter
+*Multi Meter
--   Miniature File Set & Exacto Knife (Cut Version)
+*Miniature File Set & Exacto Knife (Cut Version)
--   Kapton Tape
+*Kapton Tape
--   30 AWG wire
+*30 AWG wire
--   Small screw phillips screw drivers
+*Small Phillips Screwdriver
 ---