Retro GEM GC Installation: Difference between revisions

← Older edit

@@ Line 15: / Line 15: @@
 The doc assumes you are doing a no cut (Replace analog or digital port) installation in your GameCube.
-If you are upgrading an existing GCDual or other installation and wanting to do the case cut you will need the 3D printed spacer to mount.
+If you are upgrading an existing GCDual or other installation and wanting to do the case cut you will need the 3D printed spacer [[https://docs.pixelfx.co/GEM_PRINTS/GCDUAL_MOUNT.stl]] to mount.
-[[https://docs.pixelfx.co/GEM_PRINTS/GCDUAL_MOUNT.stl]]
 Blueshell3D has created a very nice [[https://www.printables.com/model/1244072-gamecube-replacement-rear-io-panels-for-retrogem:3D printed backplate]] that allows for full-size HDMI in the GCDual cut location. This is a great option for people wanting to keep both ports while keeping full size HDMI at the same time.
 === Kit Contents ===
+* GC Main Flex
+* Full Size HDMI Adapter Board
+* Male HDMI Adapter
+* 150mm 18p FFC Cable
+* FR4 Mount
+* M1.6 Screw mount (2x)
+* M1.6 Screw 3mm (2x)
+* Wifi Antenna
+* M2 Screw
+* M2 Nut
+* Plastic HDMI mount
 === Items Required ===
+* Temperature Controlled Soldering Iron
+* Leaded Solder
+* Non-Corrosive, No Clean Flux (Amtech 559 / Kester 959T)
+* 99% Isopropyl Alcohol
+* Multi Meter
+* Exacto Knife
+* Small screw Phillips screw drivers
+* Side cutters
+== GEM Jumpers ==
+== Disassembly ==
+== Installation ==
+=== HDMI Mount ===
+==== No Cut Mounting ====
+==== Cut Mounting ====
+=== PCB Mount ===
+=== Flex Installation ===
+==== DOL-001 ====
+==== DOL-101 ====
+=== Mounting the GEM ===
+=== HDMI FFC ===
+=== Reassembly ===
+== First Bootup ==